.
.
General properties:
Wireless alarm button RS1-P2 consists of transmitter RT1-P2 and receiver RR1-P and is designed for transmission of two signals (alarm and alarm restore) for the distance up to 500 m.
The transmitter RT1-P2 is made in plastic enclosure.
The following items are located on the enclosure of transmitter:
For transmission of signal it is necessary to hold the button pressed longer, than half a second. Thus the indicator of transmission will light. The device will be in transmission mode all the time while the button is being pressed. Therefore, it is not recommended to keep the button pressed longer than three seconds.
The receiver RR1-P is designed for receiving the information from the transmitter RT1-P2. The receiver is made in plastic enclosure.
By pressing "A" button on the transmitter RT1-P2, the receiver makes active the output (encloses contacts of the relay) and blinks indicator "Power". By pressing "B" button on the transmitter RT1-P2, the receiver returns the output in normally open state and indicator "Power" stops blinking. Pressing "Reset" button on the receiver also put an output in normally open state and indicator "Power" stops blinking.